Symmetricom Time Server User Manual download pdf (Page 82)

4-68 TimeVault™ User’s Manual 6000-100Ch4.fm Rev. D

Chapter 4: Serial or Telnet I/O Functions Extended Function Commands

Use a “get” command to retrieve data from the unit and have it delivered, through the FTP

software, to a specified directory on your C drive. You must use the UNIX format with

forward slashes to specify your IP address and the target directory. The FTP software

delivers the data in a configuration file. Once this file is in the directory, use any text

editor to modify it.

Use a “set” command to transfer the modified data from the configuration file in your

directory back to the unit. Once again, you must specify your IP address and the directory

on your hard drive that contains the configuration file. “Set” commands cause the unit to

reboot. A confirmation prompt appears, to which you must respond affirmatively (“y”)

within 10 seconds, before the unit executes the command and resets.

In a “get” command line, you can enter the elements “ntp”, “snmp”, and “get” in any order. If

you want to configure both NTP and SNMP at the same time, place both elements in the

command line.

In a “set” command line, you can enter the elements “ntp”, “snmp”, and “get” in any order. If

you want to configure both NTP and SNMP at the same time, place both elements in the

command line.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 147 148

No comments

Symmetricom Time Server User Manual Page 82