Symmetricom Time Server User Manual download pdf (Page 89)

6000-100Ch4.fm Rev. D TimeVault™ User’s Manual 4-75

Extended Function Commands Chapter 4: Serial or Telnet I/O Functions

timeout = after sending a command to the modem, the time

interval, in seconds, that TimeVault waits for a

modem response before timing out

duration = duration, in seconds, of a single ACTS session,

starting after the modem detects a carrier

delay = reserved for factory calibration only; do not change

period = time interval, in minutes, between call attempts

flag = set to ON by default; do not change

speed = baud rate, set to 9600 by default; reserved for

factory calibration only; do not change

fudge = reserved for factory calibration only; do not change

pollcounter = determines time precision vs. risk of unsuccessful

call; reserved for factory calibration only; do not

change

center = calibration of the phone line; reserved for factory

calibration only; do not change

modemInit = modem initialization string; reserved for factory

calibration only; do not change

2. Edit the data in the “acts.conf” file by adding or renaming servers from this list.

3. Return the revised data to TimeVault by sending a “set” command:

F100 config set acts host:192.168.1.14

dir:temp

TimeVault responds:

Are you sure? (y/N)

If you answer “y”, TimeVault responds as follows*, then resets:

Source file temp/acts.conf bytes read: 149

Dest File/config/acts.conf bytes written: 149

Configuration files transferred successfully!

follows each line

As a safety feature, after sending this command, you have 10 seconds to respond

affirmatively (enter the letter “y”) to the confirmation prompt, after which TimeVault

executes the command and resets. Within that 10 second time period, any other response,

including no response, results in TimeVault canceling the command.

When sending a “set” command, the last number in TimeVault’s response (“149” in this

example) represents file length. Depending on your parameters, this number may vary.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 147 148

No comments

Symmetricom Time Server User Manual Page 89