Symmetricom Time Server User Manual download pdf (Page 65)

6000-100Ch4.fm Rev. D TimeVault™ User’s Manual 4-51

Command List Chapter 4: Serial or Telnet I/O Functions

4.2 Command List

The following table lists all serial/Telnet commands that are used to operate, administer,

and maintain the unit. The Utility Port is ready to receive these commands once the

power-up sequence is complete. The F100 series is used mainly to request or set unit NET

Port parameters. Configuration of the IP Address, Subnet Mask, Default Gateway, and

DHCP parameters is also available through the front panel keypad. Changing any

network parameter causes the unit to reboot.

Table 4-1: F-Series Function Commands

Use the front panel keypad to set initial system configuration values at first installation.

Command Function Parameters

F03 Time/Date Request MM/DD/YYYYHH:MM:SS

F18 Software Version Request –

(equivalent to F100 VER)

F36 Network Configuration Entry/Request EA, IP, SM, G

(equivalent to corresponding F100 commands)

F53 Operating Mode Request –

F60 Satellite List Request –

F67 Leap Second Information Request –

F72 Fault Status Request –

F100 BASET 100Base-T/10Base-T Entry/Request 10, 100

(change requires confirmation within 10 seconds)

F100 DHCP DHCP Control ENABLE/DISABLE

(change requires confirmation within 10 seconds)

F100 EA Ethernet Address –

F100 IP IP Address ### ### ### ###

(change requires confirmation within 10 seconds)

F100 SM Subnet Mask ### ### ### ###

(change requires confirmation within 10 seconds)

F100 G Default Gateway #### #### #### ####

(change requires confirmation within 10 seconds)

F100 IC Network Configuration Request IP, SM, G

F100 P Password Change Request XXXXXXX

F100 ST Self Test Results Request –

F100 VER Software Version Request –

F100 T Request Current Time Source GPS, ACTS, or NTP

F100 CONFIG NTP, SNMP and ACTS Configuration “GET” , “SET”, “NTP”, “SNMP”, “ACTS”, “IP

ADDRESS”, “YES”, “NO”, “W”, “R”

(change requires confirmation within 10 seconds)

F100 LOCK Remote Lockout LOCK

(change requires confirmation within 10 seconds)

F100 L Lock Display Request –

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 147 148

Comments to this Manuals

No comments

Symmetricom Time Server User Manual Page 65

Comments to this Manuals

Related products and manuals for Hardware Symmetricom Time Server