Symmetricom 58502A User Manual download pdf (Page 15)

Chapter 1 Getting Started

Connecting a Terminal or Computer to the 58502A

User’s Guide 1-5

To Connect AC Power

The nominal ac input range is 100-132, 175-240 Vac, 47-63 Hz, 40 VA.

The power module or jack senses the incoming voltage and

automatically selects the proper setup. Just connect the proper ac

power using the supplied power cord.

Connecting a Terminal or Computer to the

58502A

NOTE You may skip this section if you do not plan to use a terminal or

computer; proceed to the power-up procedure, starting on page 1-9. The

58502A may be operated without a terminal or computer. The

computer is needed for you to remotely monitor the status of the

58502A and to change setup parameters.

1 If you are going to communicate with the 58502A using a terminal or

PC (personal computer), connect the computer to the rear-panel RS232

port using an HP 24542U interface cable (or equivalent RS-232 null-

modem cable with DE-9S female connectors at each end) as shown in

Figure 1-2.

Figure 1-2. Connecting a PC or Terminal to the 58502A

2 Turn the terminal or computer on.

If you are using a personal computer (PC), you will need to run a

terminal emulation or telecommunication program on your PC in order

HP 24542U or

F1047-80002

or equivalent

Interface

cable

(DTE)

RS232

123456789101112

5 VRMS MAX

100-240 VAC 50/60GHz

40 VA Max

58502A

Distribution

Amplifier

Terminal or PC

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 87 88

No comments

Symmetricom 58502A User Manual Page 15